Copyright FoldingCamperInformation 2009 - Site maintained by ImpactWebMasters.co.uk

You Are Here -

Contact Us on 01604 785400

www.FoldingCamperInformation.co.uk

Make: Conway

Model: Cruiser  -  The Cruiser is a mid range six berth folding camper with fridge, mains 240v. Later models have sprung beds. Awnings are an optional extra.   Please note: Early models mentioned below are till 2003, Later models are from 2004 - 2007. For 2008 models please see Pennine Pullman

Set up Instructions

External

• Apply brake, level with the jokey wheel and wind down the legs
• Level the trailer front to back, not side to side
• To remove cover, early models, undo shock cord  fold and remove
• Later models, undo shock, fold in half then fold in half again
• Take back corners and bring them to the front centre of the trailer, making a triangle shape
• Now roll cover forwards, it can stay rolled above gas locker
• Long bed supports are used at the back, short at the front
• Undo door zip and lower door
• At the back of the trailer pull out and lock bed supports
• Early models, with bed support set in the short position, insert into chassis
• At the back of the trailer, lift poles and canvas whilst pulling bed out
• When fully out open zip and place pin in hole in runner, inside trailer
• Drop bed support down from under bed and fix straps
• Early models, insert bed supports into “A” frame and bed and pull out and up at same angle as supports
• Pull out until pin pops out and bed is locked into place
• Later models, pull beds up and out at same angle as supports till pin pops out
• Front beds lift poles and canvas and pull out bed
• When fully out place pin in hole in runner inside trailer
• Drop bed support down from under bed and fix straps
• Now lift bed at same angle as supports till pin pops out and bed is locked into place

Internal

• Step inside and place pins in slide to stop beds returning back in centre
• Upright pole locks into place by pulling top to centre and pushing locking plastic joint to make pole stand in upright position
• Lift wardrobe on hinge and sit on cupboard
• Remove seat cushions and stand on table to one side
• Lift sink / hob into place, hinged earlier models, no connections to make, later models.
• Later models lift into place then plug in gas, water and electric plug
• Fit the shelf unit if supplied onto sink, early models free stand on cupboard
• Set up seats by placing backrest in place
• Clip up inner tents and roof linings
• Curtains fit on wire attached to the poles