Copyright FoldingCamperInformation 2009 - Site maintained by ImpactWebMasters.co.uk

You Are Here -

Contact Us on 01604 785400

www.FoldingCamperInformation.co.uk

Make: Conway

Model: Cardinal  -  The Cardinal is a mid range six berth folding camper with fridge, mains 240v, later models have a toilet, hot water, oven and sprung beds. Awnings are an optional extra.

Set up Instructions

External

• Apply brake, level with the jokey wheel and wind down the legs
• Level the trailer front to back, not side to side
• Turn gas on and remove any bits from gas locker
• Unclip four roof locks, insert winding handle and wind roof to full height
• Slide beds fully out and fit bed supports. Long bed supports are used at the back, short at the front
• With back bed support set in short position, insert into chassis. Front supports locate into “A” frame and bed base
• Now pull beds up and out at same angle as supports, till pin pops out
• Not all models have adjustable supports, some are fixed length
• Pull down bed end zip so they are 3/4 zipped up

Internal

• Step inside, locate bed end roof bars onto plastic lug on bed end pole, then slot into bracket on trailer roof
• Later models lift wardrobe into place on cupboard
• Unclip door from roof and lower so two locating pins go into holes on trailer
• Push top of door into place and lock with twist locks. Unlock and open door, make sure it moves freely
• Fit canvas to door frame by folding back and pushing into slot
• Pull canvas down around bed ends, do up zips and fit shock cord
• Early models, lift wardrobe and hob / sink into place
• Later models with toilet see note below, there are three types of compartment
• Remove seat cushions and stand table to one side
• Put sink into place next to toilet, tap screws into place, plug in water and electric plug
• Lift hob into place, hinged, gas stays connected
• Fit shelf unit to side of toilet, hooks on top. Clip up inner tents and roof linings. Curtains fit on wire attached to the poles

TYPE 1 Toilet Compartment - in 4 parts. Left/Right sides, door and tie bar.

• Lift left side and front into place, fix with clip and screw
• Right hand side fits into place with clip and screw
• Door locates onto three split hinges
• Wooden tie bar goes across back at top, to hold firm

TYPE 2 Toilet Compartment - Just door and the tie bar loose.

• Lift left side until upright, then front panel, and clip together
• Fit door surround to front panel
• Then lift right panel and fit door surround
• Wooden tie bar goes across back at top, to hold firm

TYPE 3 Toilet Compartment - no loose panels

• Lift front panel and door hinged, till upright, open door
• Lift top plate on first side, then lift panel into place and fix with top plate
• Lift top plate on second side, then lift panel into place and fix with top plate